Splice core starts jaming after several hours
Hi,
i’m using OctoPi with a Palette 2S Pro. Last Firmware is installed. I’m using the endurance Mode with (0,0,0) as Splice settings. The Splice comes out very nice, but after several hours of printing the core suddenly gets jammed (about 2-3 hours and nearly 40-50 splices ).
I tried the same print without the lid of the Palette and manage to get a bit further about 4-5 hours and 70-80 splices but not finished.
When i try to reduce the heating to stop the tube from (i think overheating over time) the splices are getting brittle and not useable.
Is this a good question?