Palette/Palette+

Resources for Palette and Palette+.

74 Questions View all
User avatar

Options

Trying to calibrate with Prusa i3 Mk3

After slicing the test STL files, trying to load the gcode into Chroma results in “Syntax error encountered” Line 6337: No duration parameter supplied for dwell instruction (e.g. G4 P2000 or G4 S2) Using PrusaSlicer 2.2.2.

Are there special settings in either Chroma or PrusaSlicer to resolve this issue?

Answer this question I have this problem too

Is this a good question?

Yes No
Score 1
Add a comment

1 Answer

Filter by:
Most Helpful Newest Oldest
Most Helpful Answer
User avatar

Options

Hey @solar_winds, thanks for reaching out about this. This is likely because there is no duration indicated at the line “G4” (or “G4 P”). Could you change the line to “G4 P0” where P is the dwell duration in ms? That should resolve the issue.

Was this answer helpful?

Yes No
Score 1

Comments:

That got me over that bump, but is hardly a long term solution.

Thank you.

by

Add a comment

Add your answer

Author avatar Jim Funk will be eternally grateful.
View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 7

All Time: 252

Contact Mosaic Support Team

© 2023 Mosaic Manufacturing Ltd.