Home/Auto Bed Level during Palette Filament Creation
Hi Mosiac,
I have a CR10-S5 that uses 25 point auto bed leveling with a BL Touch. I would like to trigger a G28 and G29 (Auto Home/Bed Leveling) while the Palette is creating the initial length of filament.
I have tried putting the G28/29 in the gcode of Octoprint (but that makes the Palette wait for the bed leveling to complete prior to creating the filament.
With the G28/29 in the sliced code it waits for the printing to start before performing the functions.
I would like to use the ‘dead time’ while the Palette is creating the initial to perform these functions..
Is this a good question?