Printer is Done Before Palette
My CR-10 finishes printing before the palette is done splicing, so the color is off on my prints.
Is this a worthwhile discussion?
Score
0
602
1 Reply
Hey @victorpitta, thanks for reaching out about this. If your print is unfinished and there is still filament left in the outgoing tube, please try increasing your Bowden tube length on your CANVAS printer profile (found under the Extruder tab). You can overestimate this value, as all it does is add filament to the end of the print, to make sure there is enough to be caught in your drive gears in order for your printer to finish the print. Hope that helps and please let us know if you continue to have issues.
Was this reply helpful?
Score
0
