Skip to main content

I tried making a multi colored print with Devil Design PETG.

I wanted to make a multi color print with my Palette 2s pro with PETG form Devil Design. It already cost me 2 slice core tubes, since the filament is stuck insite after 5 to 8 slices.

My PLA was to brittle so i broke too easy.

Is this a typical PETG error, or should i look for my problem elsewhare?

Answer this question I have this problem too

Is this a good question?

Score 0
Add a comment

1 Answer

Hey @renevandelft, thanks for reaching out. In order to print with PETG, you would have to run a splice tuning test (instructions here) to find the correct combination of heat, compression, and cooling for a strong splice. You would then have to apply these splice settings to your projects in CANVAS. Hope that helps for now and please let me know if you have any questions about the steps!

Was this answer helpful?

Score 0
Add a comment

Add your answer

Rene van Delft will be eternally grateful.
View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 5

All Time: 45

Contact Mosaic Support Team

© 2021 Mosaic Manufacturing Ltd.