Not possiblöe to the start the Splice Demo

Question

Mosaic Palette PLUS

1 Questions View all

Jens Bahn @jens

Rep: 1

Posted: 12/02/2020

Options

Not possiblöe to the start the Splice Demo

Hello i have an Palette+ new, but when i try to start a Splice Demo or a Print The Error Message “FILAMENTPATHERROR ERROR '#302 ist shown, i try all the options but i don´t work

Answer this question I have this problem too

Is this a good question?

Yes No

Score 0

Comments:

Hello for Testing i try an Opto Sensor from my Printer it works, But the next Problem is, the splicer cool down in the Demo da don’t Heat, But when i Heat Manuel this works

12/10/2020 by Jens Bahn

Hi Jens, I've reached out and will send you a replacement electronics tray.

12/11/2020 by Jonny Yeu

Add a comment

3 Answers

Hello for Testing i try an Opto Sensor from my Printer it works, But the next Problem is, the splicer cool down in the Demo da don’t Heat, But when i Heat Manuel this works — Jens Bahn
Hi Jens, I've reached out and will send you a replacement electronics tray. — Jonny Yeu

Jonny Yeu @jonnyyeu Rep: 6.2k · Answer 1 · 2020-12-03T13:28:59-07:00

Jonny Yeu @jonnyyeu

Rep: 6.2k

Posted: 12/03/2020

Options

Hi Jens, we spoke about this over FB (https://www.facebook.com/groups/mosaic.u...), and we’ll have a replacement Opto and Opto T sent to you immediately.

Was this answer helpful?

Yes No

Score 0

Add a comment