Adjusting tower print speed

Question

CANVAS

The world's first multi-material slicer.

85 Questions View all

Stefan @biberfamilie

Rep: 13

Posted: 12/02/2020

Options

Adjusting tower print speed

Using Canvas I set the Tower print speed to 50mm/s (and just for testing to 100mm/s) after slicing and downloading or sending to Canvashub it always is cut down to about 30mm/s.

I don’t need the 100mm/s but a little higher to speed up the print would be nice. Did I miss checking somewhere an option in the slicer settings?

Answer this question I have this problem too

Is this a good question?

Yes No

Score 1

Add a comment

2 Answers

Alina @alina Rep: 9.4k · Answer 1 · 2020-12-02T08:48:06-07:00

Hey @biberfamilie, thanks for reaching out about this. Could you share this CANVAS project with me so I can take a look at the GCode on my end (instructions here)? Thanks!

Hey @biberfamilie, it looks like your speed for the tower is being limited by CANVAS in order to avoid buffer errors. There is currently not an option to turn this limitation off - it’s triggered by a combination of your print and splice settings. 100 mm/s is a little too fast for Palette’s buffer to keep up with, we usually recommend a speed of~ 50 mm/s.