I just received my Pallete 3 Pro, and am attempting to connect it to my Ender 3v2. I have replaced the original mainboard with the SKR Mini E3 v3.0 board because the original board died.
I can get the pallete to connect to the printer, and home x and y, but not Z. Can someone please offer some reasonable explanation?
Device isn't supported is NOT AN ACCEPTABLE RESPONSE MOSAIC...
Is this a good question?
After doing a factory reset, and compiling then flashing a custom marlin firmware on the SKR Mini E3v3 board, I was finally able to get the printer connected, and homed all three x,y, and z.
Was this answer helpful?
I love HATCHBOX PLA 3D Printer Filament. This is great because it does not require any heated print plate.
Was this answer helpful?
i also like to hear your fvourite printer filaments.
Past 24 Hours: 0
Past 7 Days: 0
Past 30 Days: 12
All Time: 112
Hey Dave, we are copmatible even with the new mainboard. Can you share your start GCode with us?
by Jonny Yeu
Its the GCODE coming directly from the Pallete, so I have NO IDEA what it was..
by Dave B
Hi Dave, that would be the MCFX file, you can send that to us and we can examine your GCode from that file.
by Jonny Yeu
THERE WAS NO PRINT. This was JUST USING THE MANUAL CONTROLS ON THE DISPLAY. No print involved.
by Dave B