EN

Site Navigation

Your Account

Choose Language

Printing and Calibration

Printing guides and calibration resources for Palette 3

39 Questions View all
User avatar

Options

Canvas versus P2PP PrusaSlicer

Hello,

I am printing perfectly with Canvas / P3P / Prusa Mini. I have a .6mm nozzle so I'd like to get PP2P working as well so that I can use Arachne, but the color transitions are off. From what I can tell the settings across the two appear to be identical, with the exception of the Arachne engine in PS. Any advice for PP2P / PS? Is Arachne supported for this purpose?

Could anyone share a successful P3P profile for the Mini?

Thanks,
Scott

Answer this question I have this problem too

Is this a good question?

Yes No
Score 0
Add a comment

1 Answer

Filter by:
Most Helpful Newest Oldest
User avatar

Options

Hi @sbraskett, apologies for the delay on this post.

With color transitions being off, it would be good to continue to check pings throughout the print on Palette for any fluctuations from one ping to another. Print speeds with a 0.6mm nozzle should also be reduced when printing with Palette, as we primarily tested with 0.4mm.

On P2PP's side, it would also be good to revisit the purge volumes.

Block Image

I believe Tom of P2PP is looking to receive any feedback if any features in Prusaslicer 2.5 affects the P2PP plugin. We have not yet had a chance to test the perimeter generator, but if you enable it and run into anything the P2PP community help group would be the best place to share feedback on it.

Was this answer helpful?

Yes No
Score 0
Add a comment

Add your answer

Author avatar Scott Braskett will be eternally grateful.
View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 6

All Time: 89

Contact Mosaic Support Team

© 2023 Mosaic Manufacturing Ltd.