So i have just been informed about the Tower Delta function on the P2, is this possible to have on the P3P at all?
I would really like to have this on the P3P due to so much waste on my prints?
@Jonny
Is this a good question?
Hope this works?
Was this answer helpful?
Thanks for sharing. If this is a feature within PrusaSlicer, you should be able to use this with your P3 via P2PP. I'd recommend reaching out to the P2PP FB support group just to check: https://www.facebook.com/groups/59127121...
Unfortunately i have a P3P as per my question if this can be done on the P3?
Yes, it should work for both P3 and P3P.
Past 24 Hours: 0
Past 7 Days: 0
Past 30 Days: 1
All Time: 31
Hey Dave, could you please clarify the tower delta function that you're referring to?
by Jonny Yeu
[image|6052]
This here Jonny, is this possible with the P3P?
by Dave