Rep: 1
On a scale from 1 to … umm … 1 … how frustrating is this?
You don’t have to answer that, but I’d very much like to learn why it happens and what I can do to avoid it?
At the end of the print there was about 4 inches of the lighter color left in the extruder.
Rep: 1
Rep: 1
Rep: 1
I must be doing something fundamentally wrong; I have two successful prints out of many attempts, both are the Mosaic keyring thing and I don’t need any more of those. ;)
My prints seem to start out OK but then the layer colors seem to drift out of sync. Any tips on what to do/check/calibrate would be much appreciated.
Past 24 Hours: 0
Past 7 Days: 4
Past 30 Days: 33
All Time: 33
I believe some of my problems may have to do with short(-ish) splices in combination with the loading length problem I’ve described in my other post. Increasing the model size as well as the purge amounts seems to work better, I guess that increases the margins.
by Anders Östberg