Blank space in print
When i print the calibration Keychain, i always have this “blank”space,(no matter What i do)which you can see in the photo…
Is this a worthwhile discussion?
Score
0
2354
1 Reply
Does this only happen when printing with the palette?
I had a similar issue with my Dremel 3D45 when Ì fed it whith 3rd party filament. It turned out the issue was caused by a combination of print speed and too much resistance when it pulls the filament.
Optimizing the 'filament path' helped for me.
Was this reply helpful?
Score
0
Yep, it only happens with palette
Have you tried pulling your filament manually out of the palette through your bowden setup? Bad splice settings can also impact the filament 'flow'. If the splices bulge up too much, this also causes additional resistance especially when the filament has to pass the narrow curves withing the palette device.
Everything seems to be good, all the splices are okay @piddey
