Skip to main content

The world's first multi-material slicer.

29 Questions View all

Selectable Prusa Mini printer profile

When will it be possible to select Prusa Mini profile from the Canvas printer setup, as it is with Prusa MK2S and MK3S?

Answer this question I have this problem too

Is this a good question?

Score 1
Add a comment

1 Answer

Most Helpful Answer

Hey @allan, thanks for reaching out about this. We are working on integrating a preset printer profile for the Prusa Mini on CANVAS, but in the meantime, here is a share link to the one we are using. We also recommend printing this extruder clip. Our setup involves the small outgoing tube (500 mm), which was curved up and around in order to create more room for the printer to move its Z axis. We also found that loading filament at the beginning of a print was a bit tricky, as the Palette can't keep up with the fast load of the Mini, so it's important to pre-make extra filament from Palette (you can just pull some out slowly) before loading it into the extruder otherwise Palette might run out of buffer. We also use the Hub in our setup, which helps with calibration. Hope that helps!


Was this answer helpful?

Score 1
Add a comment

Add your answer

Allan Hansen will be eternally grateful.
View Statistics:

Past 24 Hours: 1

Past 7 Days: 12

Past 30 Days: 37

All Time: 73

Send our support team a message

© 2020 Mosaic Manufacturing Ltd.