Skip to main content
Canvas

Multi-material slicer for Palette

295 Questions View all
User avatar

How to add material at end of print job

So I have an issue (thats most likely related to my printer setup). When I attempt to print something sliced with canvas the palette 2s pro I have slices and splices perfectly fine except when the print makes it to the last maybe layer or so. The palette isnt adding enough material at the end of all the slices and due to this the filament makes it through the extruder and doesnt get pushed through the hotend for those last few layers.

So how would one go about adding something in the settings to tell it to make an additional amount of filament at the end?

Answered! View the answer I have this problem too

Is this a good question?

Score 1
Add a comment

2 Answers

Chosen Solution
User avatar

Extend your tube length by how much you think it would need, that should see your problem fixed.

Was this answer helpful?

Score 1

Comments:

In the configuration of the printer with-in canvas OR on the palette's tube length configuration?

by

After reading the description it makes since now. Thank you.

by

Add a comment
Most Helpful Answer
User avatar

Set the “Bowden tube length” in canvas longer.

Note: this number is different from the “outgoing tube length” and “loading offset” and it only affects the last piece of filament made.

Was this answer helpful?

Score 3

Comments:

Thank you , this fixed the problem I was having.

by

Add a comment

Add your answer

Author avatar Woodrow Collins will be eternally grateful.
View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 1

All Time: 43

Contact Mosaic Support Team

© 2023 Mosaic Manufacturing Ltd.