Skip to main content

Where to change settings for extruder

Hello, my extruder takes 147.8mm to get out 100mm exact. When i go t print with the palette 2S Pro i run out short…. how can i make sure the palette taks the same extrution rate??

Answer this question I have this problem too

Is this a good question?

Score 1
Add a comment

1 Answer

you can add length as if you have bowden tube, i have direct drive i do this to have filment left over

Was this answer helpful?

Score 0

Comments:

I think its a different question, where can we fix the e-steps for extruder in Canvas? Thanks!

by

Yes indeed, where can i fic e-steps!

by

Add a comment

Add your answer

Roland will be eternally grateful.
View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 8

All Time: 15

Contact Mosaic Support Team

© 2021 Mosaic Manufacturing Ltd.