Skip to main content

Palette 3 compatible with klipper firmware?


I have a 3d printer running klipper on a raspberry Pi. Can the Palette 3 interface with klipper?

Answer this question I have this problem too

Is this a good question?

Score 0
Add a comment

1 Answer

Hey Ant, Palette doesn’t interface directly with Klipper, but it is compatible with printers that use this firmware.

Was this answer helpful?

Score 0


Will Palette 3 allow the same commands from klipper that Palette 2 did?

Palette 2 Commands¶

The following command is available when the palette2 config section is enabled:

PALETTE_CONNECT: This command initializes the connection with the Palette 2.

PALETTE_DISCONNECT: This command disconnects from the Palette 2.

PALETTE_CLEAR: This command instructs the Palette 2 to clear all of the input and output paths of filament.

PALETTE_CUT: This command instructs the Palette 2 to cut the filament currently loaded in the splice core.

PALETTE_SMART_LOAD: This command start the smart load sequence on the Palette 2. Filament is loaded automatically by extruding it the distance calibrated on the device for the printer, and instructs the Palette 2 once the loading has been completed. This command is the same as pressing Smart Load directly on the Palette 2 screen after the filament load is complete.

Palette prints work by embedding special OCodes (Omega Codes) in the GCode file:

O1...O32: These codes are read


@zedicus No, P3 currently does no accept external commands. However, I can definitely forward this request to our team in hopes of developing something for the future.


Add a comment

Add your answer

Ant will be eternally grateful.
View Statistics:

Past 24 Hours: 0

Past 7 Days: 4

Past 30 Days: 28

All Time: 118

Contact Mosaic Support Team

© 2021 Mosaic Manufacturing Ltd.