Skip to main content

Palett makes all Filament at once

When I start the Palett it makes the hole Filament and does not give further instructions anymore to load it into the printer. I am not sure why. I already tried a lot. Resetting the Palett, reupload the firmware. But it did not change. The Palett still makes the hole Filament for one print and says then that there are no pings and pongs (obviously, because the printer does not get the Filament, because the Palett does not wait anymore..)

In the beginning it worked for the first prints. But now i do not get the Problem anymore. Maybe someone here can help me out.

Answer this question I have this problem too

Is this a good question?

Score 0
Add a comment

1 Answer

Hey Anja, this may have something to do with your homing switch. Under Settings > About > Next > Next, does your homing switch status change when filament is loaded?

Also, can you share a video of what is happening? This can sometimes provide additional information about possible causes.

Was this answer helpful?

Score 0
Add a comment

Add your answer

Anja will be eternally grateful.
View Statistics:

Past 24 Hours: 0

Past 7 Days: 7

Past 30 Days: 20

All Time: 1

Contact Mosaic Support Team

© 2021 Mosaic Manufacturing Ltd.