Skip to main content

Seeking help with excessive initial filament feed

At the start of the job, mosaic requests what seems and an inordinate amount of filament eg 450mm to get to the extruder. If i undertake this suggestion large amount of filament is extruded, obviously. If I cease the extrusion when filament starts to leave the hot end, I get quite inappropriate colour layering.

Answer this question I have this problem too

Is this a good question?

Score 0
Add a comment

1 Answer

Hey Julian, I would suggest factory resetting, then re-calibrating. It sounds like the loading offset is off from your initial print, which is causing these issues.

Also, which outgoing tube length are you using?

Was this answer helpful?

Score 0
Add a comment

Add your answer

Julian Monfries will be eternally grateful.
View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 34

Contact Mosaic Support Team

© 2022 Mosaic Manufacturing Ltd.