Skip to main content

random mode not random

I tried to have the pallette2 mix a bunch of left over filament together. I told it to do it randomly for a total of 200m of filament. It started fine, but after an hour or two it would only pull from input #4. It stopped being random or using 1 -3 altogether. It only would pull from #4 and would pull it completely. Why did this happen? What is the fix? I now something like 100M of filament I wanted to add to but I can’t because it isn’t working correctly.

Answer this question I have this problem too

Is this a good question?

Score 0
Add a comment

2 Answers

Hey @jj1212120, thanks for reaching out about this and sorry for the trouble. Unfortunately we have not seen this issue before - could you confirm that you have followed all the steps here: mm3d.co/p2random

Was this answer helpful?

Score 0
Add a comment

Page isn’t working at the moment, but I think I did. It started as random and was random for the 1st hour or so. It wasn’t until after it ran for an hour or two that the issue occurred.

Was this answer helpful?

Score 0

Comments:

Sorry about that John, I have updated the link in my previous comment. Could you double check the steps and let us know if these are the steps you took as well?

by

I went through all of the steps. It was random for the 1st hour or so. After that time it stopped being random and stopped pulling from other inputs except #4.

by

Add a comment

Add your answer

John Johnson will be eternally grateful.
View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 27

Contact Mosaic Support Team

© 2021 Mosaic Manufacturing Ltd.