Skip to main content

Da Vinci Pro 3-in-1 no connection

Hallo,

I have the Da Vinci Pro and i am trying to connect the Canvas Hub with it, but i get “no working port/baudrate combination detected”. i used auto and manually tried every combo. Is there any way to connect or is it just not possible?

Answer this question I have this problem too

Is this a good question?

Score 0
Add a comment

1 Answer

Hey @jeroenm, thanks for reaching out about this. Unfortunately, this printer is not listed as compatible with OctoPrint (likely due to custom firmware), which is needed for the Hub. However, this forum post here indicates it may be possible if you reflash firmware with Repetier. You can also use Palette without the Hub, in accessory mode.

Was this answer helpful?

Score 0
Add a comment

Add your answer

Jeroen Meilink will be eternally grateful.
View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 23

Contact Mosaic Support Team

© 2021 Mosaic Manufacturing Ltd.