No unanswered questions in the past 24 hours!
New Firmware update P3P
unanswered Firmware and Controls 0 Answers
no communication with ender 3 v2 neo
discussion Palette 3 0 Replies
Why won't calibration stop feeding filament AND fuse?
discussion Palette 2 (S) (Pro) 0 Replies
How to Export Pings and Pongs?
unanswered Firmware and Controls 0 Answers
Prusa MK4 Profile update
unanswered Canvas 0 Answers
Problem with the lid of the palette 3 pro
unanswered P3 Maintenance and Troubleshooting 0 Answers
Question regarding palette 3 pro firmware for TPU
discussion Firmware and Controls 0 Replies
How do I add cura to the splicer in canvas
discussion Palette Troubleshooting 0 Replies
Canvas plugin for Octoprint does not work
discussion CANVAS Hub Troubleshooting 0 Replies
Why is there no comprehensive instruction manual?
discussion Chroma 0 Replies
More of a Suggestion than a question.
discussion Palette 3 0 Replies
PRINTS NOT CENTERED. All my prints are in the back right
discussion Canvas 0 Replies
No Send To Printer
unanswered CANVAS Troubleshooting 0 Answers
Ender 3 S1 Canvas profile
unanswered Palette 3 Setup 0 Answers
Can you use the Palette 3 with other management software
discussion Palette 3 0 Replies
Where can we report bugs?
unanswered Palette 3 0 Answers
"Are you still there?" Camera prompt is too short
discussion Canvas 0 Replies
What version of Slic3r is used?
unanswered Canvas 0 Answers
My palette stopped doing good spice
discussion Splicing 0 Replies
Error 134 2 consecutive pings below 50 percent
unanswered Palette 3 pro 0 Answers