Only 1 of 14 questions in the past 14 days has no reply - Help answer it!
The spliced Filament is to long to properly attache the guide tube.
discussion Starting a print 0 Replies
Preparation of Colorizing 3d model
CANVAS 1 Answer
Tronxy D01 printer profile
CANVAS 1 Answer
Wipe tower is 4x higher than the print
discussion Keychain print 2 Replies
Setups above an enclosure
discussion Getting Started and Printing 1 Reply
problem palette 2 pro
problem 1 Answer
Hub S Keeps Disconnecting from Wifi
discussion CANVAS Hub S 1 Reply
CANVAS HUB S will not connect to new Network modem
discussion CANVAS Hub Troubleshooting 1 Reply
Palette+ SD card data
discussion help 1 Reply
Failed to update, now wont boot
accepted Firmware 2 Answers
Splice core starts jaming after several hours
accepted Palette Troubleshooting 1 Answer
Delete CANVAS Queue to CANVAS Hub
CANVAS 2 Answers
Extracting your sliced design?
accepted CANVAS Troubleshooting 1 Answer
Unable to access the Raspberry Pi
accepted Default Canvas Hub Password 1 Answer