Skip to main content
Help

Original post by: David Vandeweghe

Text:

Very interesting thread.

Currently I have the issue nearly each job, and always during the loading phase, after some splices and always during a splice. The outgoing filament is cut, retracted in the input then the P3P freezes, the output drive is stuck and the buffer is reduced to the minimum until the extruder starts grinding the filament or the palette goes into an error (no filament move detected).

I’m not able to perform any job, but one.

The only way to exit that state is to cancel the print. Generally no need to restart or unplug the palette, but sometimes it goes to the “finishing up all queued commands” bar, then the only option is to unplug the palette.

Status:

open

Contact Mosaic Support Team

© 2022 Mosaic Manufacturing Ltd.