Skip to main content
Help

Original post by: Alina ,

Text:

Hey @allan, thanks for reaching out about this. We are working on integrating a preset printer profile for the Prusa Mini on CANVAS, but in the meantime, [https://share.canvas3d.io/printers/2114078e1bcf69c1aaed3d7634d593d1|here is a share link] to the one we are using. We also recommend printing [https://www.prusaprinters.org/prints/20115-palette-2-tube-clip-holder-for-prusa-mini|this extruder clip]. Our setup involves the small outgoing tube (500 mm), which was curved up and around in order to create more room for the printer to move its Z axis. We also found that loading filament at the beginning of a print was a bit tricky, as the Palette can't keep up with the fast load of the Mini, so it's important to pre-make extra filament from Palette (you can just pull some out slowly) before loading it into the extruder otherwise Palette might run out of buffer. We also use the Hub in our setup, which helps with calibration. Hope that helps![br]

[br]

Status:

open

Send our support team a message

© 2020 Mosaic Manufacturing Ltd.