Skip to main content

Original post by: Rob ,


My 2 color keychain calibration print came out in a single color


I have a palette 2s with an ender 5, just finished setting it up. I ran the splicing calibration and that worked fine. I opted to use the short output hose since the palette is near the feed motor. I told the palette I'm using a short hose. My print came out in a single color and when the print was complete, the palette thought there were still 2 more transitions to be done (out of 4 total). I sliced in canvas, and since there is no ender 5 profile, I chose an ender 3 in canvas. Not sure if that is my problem.


Single color keychain print

Discussion Topic:




Send our support team a message

© 2020 Mosaic Manufacturing Ltd.