Skip to main content
Help

Current version by: Drew Privitt ,

Title:

Pings are not being detected

Text:

Hello. I currently running a palette plus with 0.2 size nozzle on my Ender 5 Plus. The pings are not being detected by the palette even though the printer is pausing over the transition tower as it should. The prints go well until about 60%. Over time because there is no feedback at all, the colors gradually start to transition at incorrect times after about 60% or 24 hrs into the print. Could this be a firmware issue? I just updated the firmware to the latest through Chroma. Thank you!
+
+[image|3563]

Category:

Palette

Discussion Topic:

No

Status:

open

Original post by: Drew Privitt ,

Title:

Pings are not being detected

Text:

Hello. I currently running a palette plus with 0.2 size nozzle on my Ender 5 Plus. The pings are not being detected by the palette even though the printer is pausing over the transition tower as it should. The prints go well until about 60%. Over time because there is no feedback at all, the colors gradually start to transition at incorrect times after about 60% or 24 hrs into the print. Could this be a firmware issue? I just updated the firmware to the latest through Chroma. Thank you!

Category:

Palette

Discussion Topic:

No

Status:

open

Contact Mosaic Support Team

© 2021 Mosaic Manufacturing Ltd.