Skip to main content
Help

Original post by: Oliver ,

Title:

Print Speed Control During Splices in mm/s

Text:

Dear Palette Team,

is there any chance to limit the print speed control in Canvas Hub also by mm/s rather than a percentage of the current feedrate?

I know that with my splice seetings around 35mm/s are fine during a splice, so there is no need to go below this value, e.g. if i print the shell with 25mm/s it’s not required to further slow down the print (which usually result in some issues).

Thank you

Oliver

Category:

CANVAS Hub

Discussion Topic:

Yes

Status:

open

Send our support team a message

© 2020 Mosaic Manufacturing Ltd.